Anyray® A1704Y Halogen 35Watt 130Volt Review

A 5 pack is very economical. The package arrived crumpled but for now the filaments are intact and the bulbs are working fine.

Fits my microwave perfectly and is a lot cheaper than name brand parts. I don't know about the durability yet, but I reckon it's about as good as the original.

Excellent quality, built to last. Works long and well in my microwave and in a table lamp. I am very satisfied with the quality of these lamps. Also, they come individually wrapped and if you cut off the end of the wrapping on each one you have a way of holding them so you don't get finger oil on them (causing halogen bulbs to fail sooner). It is great.

I have given the product a positive rating before. This is an exact march for a halogen bulb no longer sold at the big bpx store that sells fixtures. I put in a new bulb on September 15th; 19 Sep filament burned out. Installed according to the instructions, without contact with the skin, wiped with alcohol. Luckily there are 4 more bulbs in the pack and hopefully the bulb I installed today will last more than a week. I am withdrawing my product recommendation due to poor performance.

You can bend the pins to fit if they don't fit perfectly. I ordered the size indicated on the lamp, but the pins were positioned differently than the original lamp. I bent them and they worked in the lamp. Remember not to touch the bulb with bare fingers (I used a tissue to stick it inside the bulb), or if you do touch it, wipe it thoroughly with alcohol and dry before putting it in insert the lightbulb. Otherwise, oil on your fingers will create a "hot spot" and the bulb will overheat in the…

My table lamps are halogen and use this 35 watt bulb. I found a 35 watt bulb like this very hard to find locally and when I found it it was over $6 a piece! Here's a tip when installing halogen bulbs: Do not touch the bulb with your bare fingers. Residual oil on your fingers will cause a lamp "hot spot" and premature failure. Remove the bulb from its packaging, wipe it thoroughly with an alcohol wipe, and insert it into the bulb socket with a gloved hand. After installation, wipe it again with…