🔵 ARCTIC Thermal Pad 145 x 145 x 1.0 mm (Pack of 1) - Enhanced Thermal Conductivity, Cooler Thermal Compound, Efficient Gap Filler, Non-Stick, Safe Handling, Easy Application - Blue Review

Arrived sandwiched between two layers of soft plastic. One layer came off very well. The other layer stuck to the thermal pad too well and could only stretch and tear the pad. I ended up with cotton balls, torn pulp and a product that didn't do what it was supposed to do because I couldn't get it from their support. I won't buy this again.

50mm is the perfect amount to replace all 16 pads on an original PS4. I had to cut very carefully to make it fit. The pads stick well as others have said they are not very sticky. So be careful when putting the board down when carrying a PS4. It's a little pricey for the small area you get but it was enough for what I needed so can't complain.

Bought for my EVGA GTX 1060 SC graphics card. Apparently the evaporator chamber in the heatsink does NOT come in contact with Mosfits or 6GB RAM. So I removed the heatsink, cut out small squares of thermal pad and placed them (have to use two squares because the gap was so big) on top of the mosfits and ram, then reattached the heatsink. According to GPU-Z, my GPU temperature dropped by 10 degrees. I used to run from the high 60s to the low 70s, but now I run from the high 50s to the low 60s…

I'm an electronics builder and repairer of various devices and these thermal pads are perfect for my Playstation 3 and Playstation 4 memory chips. The pad itself feels good and cuts very easily! Additionally, it comes with a plastic sheet on both sides of the thermal pad, which is also easy to cut along with the pad, allowing you to cut out the shapes you want while protecting the naturally adhesive thermal pad itself until you're done. to apply to work. The only downside is that it's more…

If you are looking for these for PS4 the 1.0mm are excellent and I have used them in my personal PS4 Pro. The standard gaskets that come with the PS4/Pro don't cover the entire memory chip, resulting in overheating even after you've changed the thermal paste and cleaned the console. There are 6 chips on the CPU chip side and 8 on the back, which are larger. Cut all thermal pads to fit both chipsets. If you're interested in the post results, my personal PS4 Pro is very quiet, even with the delta

This spacer from Arctic Thermal perfectly holds my MP Delta Mini 3D printer's glass build plate in place without squeezing it Impairments comes from the bed temperature. Easily cut with scissors and holds glass without clips. I've been using a thermal pad to hold the glass platform on another 3D printer for over two years with no problems. Because this pad is thin and quite resilient, I found it easier to remove one of the protective plastic sheets and then place the glass on the pad. I could…

Up until yesterday I was planning on getting 3 or 4 stars and saying they do the job just as well as the stock pads on my Gigabyte GTX 1070 G1 with Micron VRAM. After playing around with memory overclocking yesterday I had to give it a 5 star rating. All the 0.5mm pads on my card have been replaced with this stuff and gddr5 seems to like the change a lot. Previously, I was only able to get up to 8750MHz effective memory speed before stability became an issue. After applying arctic pads to the…