🚦 Enhance Truck and Trailer Safety with AUTOSMART 2PCS Red Oval Sealed LED Turn Signal and Parking Light Kit featuring Light, Grommet, and Plug (Turn, Stop, and Tail Light) Review

Bought these to replace lightbulbs on a boat trailer as the old ones looked weak. They're nice and bright. I think they look really crisp. Installation was easy as I already had the matching 3 pin connector on my trailer. They've already survived two dives so I believe they're waterproof and probably won't have any water issues. .

The old headlights came out easily but these fit perfectly. They come with a wiring harness, but being standard they plug right into my existing wiring harness without the need for rewiring. The light is much brighter than the original and I highly recommend them for safety. Excellent quality headlights. In the photo on the left are new LEDs, on the right are old bulbs. For your health

10 minutes Direct replacement for the old Exiss trailer. The factory plug was used unchanged - carefully pry off the old lamp unit with a screwdriver and plug it in. Install the rubber grommet first, then the light assembly. Supplied with an extra plug - has not been used. Bright enough when viewed on a very sunny, clear day. I assume they are MUCH brighter than an incandescent bulb at night. Couldn't be easier

I needed to put headlights on an old RV and wanted something that was easy to fit and connect. I bought brackets that I screwed into the oval bumper and they fit snugly. Wiring is good as they come with a plug so you can fit the lights and then plug in without having to juggle the whole light with the wire already routed. The taillight and turn functions seem bright enough, unlike the old bulbs.

I have an old Haulmark van. Bought not new, I think 15-20 years. My trailer had two of these lights on each side. 4 total. Removing the old ones took longer than installing the new ones. The new rubber seals fit perfectly. Light builds fit very tightly. I'm a veteran at this stuff so it was easy on the brain but a little hard on the muscles. It took a lot of effort to get them installed properly. I used a lubricant, grease in this case, to properly install the light in the new rubber grommets…

My trailer was built before LED lighting was common so they weren't very bright especially the turn signals. These headlights were the same size so I expected them to fit well, which they did. What I didn't expect was that the original lamps had the exact same connector, so it was really a plug and play setup. Using a flathead screwdriver I popped out the original lights, then pushed, pulled, pulled to fully install the new ones (it was good, they were tight so there were no leaks) and they…

More impressed than I thought. These lights were better than I thought they were going to get an award. Arrived well packaged, intact. The headlights are bright and do their job well. I was most impressed by the rubber bushings around the headlights. I had some concerns in this area. I was concerned that they would be hard plastic and would be difficult to fit into these cutouts. The gum was shippable and of good quality. It fits perfectly in the recess. The electrical plugs and cutouts were…

Of course I read reviews, but they are only part of my decision-making process. Sometimes you just have to take a risk and try the product for yourself, which is what I did. I'm a very critical person and can find flaws in almost any design, but these taillights have top-notch build quality. And those who have criticized rubber seals, I don't know what planet they are from because they are premium quality. I would definitely recommend them to anyone who has old burned out lightbulbs in their…