🔌 Enhanced Plug-In Style Turn Signal Load Equalizer III by Badlands Motorcycle Products for Harley Review

Despite the description and documentation on the Badlands website, this model actually works with my 1996 Dyna. I installed non-aftermarket LED lights and the stock turn signal module (TSM) lit them but did not flash. The connector it fits into is under the seat and is a black connector that goes to the taillight and rear turn signals. Easy 1 minute install after removing the seat and it works like a charm. Should also work in the future when I switch from incandescent to LED turn signal bulbs.

When I replaced the bulbs on my E-Glide Classic with LED turn signals, I got annoying fast blinking. Installation took 4 minutes including removing the seat. Solved my problem immediately. If you're going to switch to LEDs and something's wrong, just pick it up, plug it in and you're good. Don't overdo it like me. Also, don't get bogged down in directions. Bike, plug that thing in, put it in the frame or tie it down, put the seat back in place and start the bike. Too simple. 👍🏻🇺🇸

Works as advertised. Plug and play for 2006 Dyna Wide Glide FXDWGI. Equipped front and rear Niligg signal lights and Sun Pie headlights. Fast resolution of hyper blinks (less than 60 seconds). Seller, please note on your item page (if you haven't already) that this item can get hot when using hazards. Wanted to use another brand but that brand only mentioned that their product is TSSM (alarm) compatible and didn't say anything about whether it would work with auto shutoff signs like yours. But…

Plug and play as directed. Good price, difficult to decide which model to choose; it was cheap with a simple description of the brake and turn signal equalizer. It turned out to be what I needed. All headlights on a 2007 FLHTCUi converted to LED. Installation was pretty easy but I had to call the company - a technician was able to help me. The problem encountered was the addition of the driver's seat backrest bracket (an unrelated problem). The bracket covered the area where I needed to connect

If you want to convert your Harley to LED lighting, this device will work without additional heating resistors. On my bike it connects to the seat belts and stays under the seat. Be sure to follow the instructions that came with it and install the Badlands unit BEFORE swapping the bulbs for LEDs. I would choose this block over adding resistors as it takes a few minutes to install, you don't have to cut into the wire harness and you don't have to add resistors which are hard to hide and can get…

This is the second company I've tried for a lightweight plug and play load balancer. The first failed twice. In the badlands, plug and play for the first time. Illuminated my LEDs like a charm. I am very glad that they are still open for customers. In addition, the post continues to serve the public. Let's go back to the wasteland. It was a very simple application. turned it on Turned on the light and watched them blink. They blinked properly, not some hyperactive kid looking for another candy.

I haven't had any problems with fast turn signals but I did a $5200 Stage 4 upgrade and when I got the bike after that upgrade the turn signals were gone. stopped turning itself off after turning. I don't know how this happened as the electrical work was not done. However, I recently installed new LED headlights and a set of daytime running lights. Since I wanted more juice for the starter due to the 10.5.1 with compression exhaust valves, the starter struggled a little more than I wanted for…