🚘 Baja Designs 447125 Black/Silver Fog Light (Toyota, Tacoma/Tundra/4Runner), Squadron Sport WC: Top Performance and Sleek Design Review

If my headlights switched to white light Baja white fog lights would be a great addition to my runner, very bright and easy to install.

Outstanding fog lights. I had Morimoto XB LED fog lights and changed them to BD. They are much lighter, fit better and look cooler than Morimotos. Quick and easy installation.

I ordered a Baja Designs fog light kit for my 2013 4Runner, very easy to install and the light is very bright. Nice update from stock and I can finally see at night.

The headlights themselves are excellent. I think they sent me a used item. It was scratched because it was pre-installed before. Also, one of the wires was pulled completely out of the connector. To fix this I had to bypass the connector and solder the wires together. The product itself is great, but they shouldn't sell damaged returns.

I wanted to buy relay spray for my Tacoma and gas cap separately. Then I found Kit 447125 on the BD website, it wasn't difficult. I searched for it in Revain to no avail and then found 4x4TruckLED. He referred me to his Revain store so I asked if he had them. A few minutes later he posted it on the website, so I lashed out. All I have to say is the phenomenal service from 4x4TruckLEDs and the output is, well, BRIGHT and wide! Thank you dear sir!

Super bright and look great. Design and build quality are very good. After seeing how good they are, I'll probably make Baja Designs for other lighting needs. They are expensive but after seeing the quality I understood. Installation is easy too, just youtube one of the installation videos. One installation tip I haven't seen anywhere else is to use tape on the tabs that hold the fog lights in place. This creates a snug fit with no play or freedom of movement. They give you cheap gum that's…

Very easy install in 4runner 2018, check out some youtube videos as the instructions are not the best. For each lamp there is a holder with a bar and one with holes. it just slides into the same spot as the OEM. I ended up using a razor blade to cut the foam they provide into thin strips so the fluted cardinal side has no play (this is a relatively new technique as the youtube setup didn't mention it). I had to test the headlights before attaching them to the wiring harness by connecting the…