🔌 Enhanced Basenor Cup Holder Insert for 2021 Tesla Model 3 Model Y with Refreshed Console Review

Am I the only one experiencing this problem? This clip is undone over and over again. The actual fit is really great but the spring clip is poor.

I didn't like that the glossy plastic on the top is a bit warped and see-through, but the functionality works well. For this money what is.

Easy installation. However, it is a bit loose in fit. If you drink something on both sides, it tends to rise with the drink. A bit annoying but otherwise works well for keeping drinks steady while driving.

We all 3 older owners know cup holders suck and everything in them rattles. This ensures a tight fit on all tumblers such as a 20oz Miir Glass, Tesla Glass, Venti Starbucks etc. However, some narrow bottom bottles will still fly. For example a smart water bottle or something similar.

I would really like this accessory. Easy to install and securely holds thin cups in place. However, this insert leaves black spots on my white mugs with black spots. These black spots are almost impossible to wash off. This lack actually makes everything useless.

Installed correctly and put in a regular sized water bottle. He's still walking like crazy. The reason for this is that the spring elements do not extend far enough to firmly attach the water bottle. waste of money. A guy here with pictures shows the same thing. To work you need a large container. Water bottles and Coca-Cola cans do not work. Maybe a branded thermos is enough.

No complaints. It doesn't match the color of the original cup holder, but I couldn't find any other cup holders. I'm planning to wrap it anyway, so that's not a problem. It definitely makes the cup holder more convenient to use and holds securely with no glue, so it's nice. I'll also be getting rubber pads for the floor so I'll update them when they're installed and see if they work well.

Great concept but serious design issues. The detent springs are not engaged and not secured. After putting a drink in the cup holder 3 or 4 times the tabs get stuck rendering it unusable. It must be renewed so that the tabs are held in place and cannot slip out. No stars just because it's a good design, extruded plastic, not 3D printed or permanent. Would be 5 stars if this tongue clip was redesigned

Great fit. But as many other reviewers point out, after 3 or 4 cup insertions, the spring retaining clips fall out and become unusable. A very nice device and if the clips didn't fall out/fall off it would be 5 stars. I've had it for a little over a month so it's too late to return it. UPDATE: Since I really like this cup holder solution, I found a solution. Holding the clips in place and then applying a dab of hot glue (or other glue) to the inside of the device where the bottom of the spring…