🔒 High-Quality BBR Motorsports Frame Cradle - Silver 321-YTR-1231: Ensuring Superior Protection and Stability Review

Excellent fit, offers good engine protection compared to the original, the bike frame bends after years, requires some finesse in installation, a little patience and mechanical knowledge. Away. It was a nice upgrade to make the frame stiffer.

High quality and rigid forged frame reinforcement. This part is mandatory along with the chain guide to avoid potentially catastrophic and costly failures. It spins with no problem, it didn't affect my exhaust. Gives priceless security if you want to tinker with your game bike. I hope this review has helped you with your purchasing decisions. If it was helpful, please upvote it. Thanks!

It took a lot of work to put in new screws. Alignment wasn't perfect. Also, I would like the long back fat to come with a washer and lock nut. I started digging into the aluminum of the cradle as soon as I started tightening it. It was quite difficult to install the screw the first time, it was difficult to pull it out to attach the washer, I just had to fiddle a bit more to put it back in. Otherwise it looks good and should serve its purpose. .

Save money. The build quality is very good, but installation was a joke. I've read other reviews of exhaust installation issues on the ttr125 but I assumed it was an installation error or the bike frame had already been modified. It wasn't like that. I have a very little used ttr125 still on original tires and the frame mount doesn't fit at all. I had to grind the bezel on the mount to clean the exhaust. The protected area of the protection plate is also much smaller than that of the drain…

Kickstand and skid plates are great. Here are some things you might want to know. I had to unbolt and hang the exhaust pipe to remove the front frame bolts. You have to put the bike on its side to get the job done. If you remove the original skid plate, the bike will spring back a little (1/4 inch). So if you're trying to align everything to put the new bolts in, you'll need to grab onto the front and back of the bike. back together to align the screw holes on the front and back of the tote…

Bought expecting it to fit. So the holes matched, but the problem was the exhaust. I had to take it off and put it back on, which wasn't hard, but the skid plate really wanted to put the exhaust back on. So everything fits, but the skid plate was thick and I had to file down the skid plate (not the actual bottom piece, just the piece that connects to the holes) with a file to get it to fit. It's still tight but I'm tired of filling it. It works as it should and all holes are aligned. I've had…