🛏️ Bed MadeEZ: Advanced Bed Maker and Mattress Elevator Review

I use this on my royal pillowcase and baby foam mattresses. I'm 5'0", so it's difficult for me to change sheets as the mattresses are quite heavy. My baby foam mattresses are on a platform bed with tents and are pushed against the walls so I can't access the bed easily can. corners of the mattress. it helps a lot! I need to buy this for my mom.

Who knew something like that existed? I stumbled upon this by accident, but I'm glad I did. It helps a lot in making my bed, especially with a heavy large mattress. I just tuck each one in between the mattress and the mattress spring and then tuck in the corners of the top sheet etc. I then use it to tuck in the edges of the sheet. Haven't used it to make a bed skirt yet. .

Much easier than lifting by hand. I used to propped up the end of the bed while my wife tucked in the corners. I'm not always there and I'm getting older. With their help, just throw the sheet over the bed, stuff it, fold the corner and pull it out. The best thing is that when you pull it out again, the sheet is not blown out by a large jet of air. Very durable and easy to use.

This device makes changing the bottom sheet SO easy! I didn't always change the sheet as often as the rest of the bedding because it was difficult and painful to lift the heavy mattress to tuck it in the corners. Leaves. Since my cervical epidural isn't due until next week and it's cold and wet, this is the week I might skip the bottom sheet. Thanks to whoever invented this wonderful product!

You will love this article. Thanks to the mathematical simplicity of the base arm, it's extremely easy and smooth to insert each of these lifters about 12 inches from the foot or top of the mattress and then pull a fitted sheet or flat sheet into place, adjusting as desired while the lifters are in position. Voila. This product was worth every penny for a one-time use. It eliminates the risk of back strain as well as the frustration of trying to catch the corner of a huge mattress with a fitted

Mattress lifters may work better with other mattresses. My California king mattress is very heavy as it is made of memory foam and can be a little deeper than some more common mattresses. I glue mattress stays near the foot end of the bed on each side. I usually place my foot on the bed frame near each corner of the bed and lift the mattress over my knee. I have to lift it high enough to tuck the sheet under the bottom of the mattress from the corner of the bed to the middle of the edge. The…

The new extra thick mattresses made it difficult for me to tuck sheets in - and I really prefer them 'tucked in'. So these little tools seemed like a godsend. I bought the deluxe pack thinking it would be easier to work between two wedges than just having one wedge and working tight on both sides. Well, not so sure. The mattress will sag between the wedges if they are too far apart. You work the same way. They don't help much with the stretchy bottom sheet that just tends to pop back out. They…