Header banner
Revain logoHome Page
befenybay sfu1204 diameter standard machining logo

Befenybay SFU1204 Diameter Standard Machining Review

2

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🔧 Linear Motion Products, 🔩 Power Transmission Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Befenybay SFU1204 Diameter Standard Machining
img 2 attached to Befenybay SFU1204 Diameter Standard Machining
img 3 attached to Befenybay SFU1204 Diameter Standard Machining
img 4 attached to Befenybay SFU1204 Diameter Standard Machining

Description of Befenybay SFU1204 Diameter Standard Machining

High service life time due to low friction; low operation noise. Ball screw diameter:12mm, ball screw pitch:4mm, ball screw length:250mm(9.84 inch). With BK10/BF10 standard end machining. The total length is 250mm and the effective ball screw length is 185mm. Do not remove the ball screw nut from the ball screw, because it is matched, or it will be difficult to install it again.

Reviews

Global ratings 2
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Fantastic Linear Motion Product!

After trying this industrial and scientific product, I was blown away by its efficiency and precision .The construction is robust and reliable ensuring that it lasts quite long. The machining process was smooth and the end result was excellent. It`s an excellent choice for those seeking a linear motion product that is both precise and efficient. Cons? I have yet to find any..

Pros
  • Smooth and accurate machining with standrad diameter.
Cons
  • May require specialized knowledge and experience to use effectively.

Revainrating 3 out of 5

Tolerances are a little sloppy

This will be for the 400mm ballscrew SFU1204. This part had some minor tolerance issues. it is not entirely eccentric and has a slight curvature. About 0.07mm long. Works fine for now, I haven't used it on my CoreXY printer, I'll probably use it in another project.

Pros
  • Power Transmission Products
Cons
  • I'll add later