🛠️ Bestauto Rear Axle Shaft Bearing Puller for Toyota Trucks (1984/2018): An Essential Tool for Efficient Bearing Removal - 09521-25011-0 Review

It worked fine on my 2010 Tundra, but the 5 inch wide flange at its smallest point makes it unsuitable with most presses. I had to modify my abs to make it work. Otherwise, it's a very hard mode and we're going to build.

Good tool for the job. Very well built. The only issue I had was that none of the flanged ends would fit my 20 ton port freight press. I had to cut off one end to finish my work. Nobody said it would fit in a 20 ton press, so that's on me. Everything else worked fine and I can weld a piece of pipe to the flange that was cut off if another car needs it.

This tool worked great on my 2008 Tundra to replace rear wheel bearings. Steel tubing for spacers, four bolts, eight washers and four nuts to create a new work surface for the press that could be unbolted to fit this tool. attached the bench press to a 2x6 pair to keep it stable.

The tool works well and extruded the retainer and bearings from the axle after I cut both sides of the round flange to fit between the support of my 20-ton fits Press . As a side note, a 20 ton HF press is ideal for removing Tundra journal bearings when using this tool. I had to loosen four bolts to allow the axle to lower 1/16" to get the tool and axle under the piston. Once the axle and tool were under the jack, I tightened the four base plate bolts and wringed then took off the bracket and…