Protect and Shine: Blue Magic 1008-24PK Liquid Glass Metallic Seal-Up® - 11.4 oz. Review

So far so good. It was a blown head gasket. Used and after 100 miles no water in the oil, no misfires. Works smoothly, the hook does not light up.

During work, the Dodge Grand Caravan overheated while driving, then went out again at idle, water bubbled in the radiator. System flushed and instructions followed, now I can drive and the sensor stays where it should. There will be an update, something will change

It works as expected though. I followed the directions on the bottle. The only thing I did extra was remove the radiator after machining and rinse well. I also drained the water through the top hose where the thermostat goes and washed off excess water. It was easy to remove, also because I didn't machine the radiator. I've used it to fill a small crack or hole somewhere in the head or block that we can't find. The thermostat has already been removed during a system flush treatment and I highly

1. It has been verified that there is no refrigerant in the oil (this product cannot be used due to the presence).2. Drained all coolant from 96 Dakota 3.9 v6. Filled it with water (leaving room for Blue Magic).3. Started the engine to warm it up to operating temperature with the radiator cap removed (and steam came out of the exhaust pipe) .4. Blue Magic filled, radiator cap on, steam stopped after 5 minutes.5. Following the directions on the bottle, I started the engine for 20 minutes and let

sealed Toyota Camry Hybrid engine that drove many miles with a blocked water pump. After repairing the pump, one liter of coolant is left every 100 km. Cylinder head gasket or cracked head. Driving with a leak has also discolored the coolant. The exhaust is probably in the coolant. After flushing the system and adding water and sealing it, the leak was gone and the coolant stayed crystal clear for the last 10,000 miles. It didn't clog the radiator, the core of the heater, and didn't cause the…

Very Good Product. Helping fix my brother's car with white smoke coming out of the exhaust. We check beforehand whether we have enough motor oil. WE REMOVE THE THERMOSTAT. We flush all the coolant in the radiator and engine. This product ONLY WORKS WITH WATER. Add water from a garden hose. Then we leave some space to fill this entire bottle. We started the car at idle until the temp gauge and fan worked for a good 20-30 minutes. Then turn it off and let it sit and cool for 15 minutes. Then we…

I used this on a 35 year old Honda VF500F bike that burned a small amount of coolant. It is very difficult and expensive to get new head gaskets (and removing one of the heads from the engine is not a problem). Let's start with a simple one.) The capacity of my engine's cooling system is about 2 liters, so in my case a small advantage. The bottle is rated for up to 6 gallons, so I used about an ounce to treat my engine. I also removed the thermostat. Otherwise I followed the instructions on the