🔧 Bringsmart Mounting Bracket 60Ktyz Support: Securely Mount and Tilt for Maximum Convenience Review

Bought this motor for turning epoxy shells. Works great, perfect speed. I give three stars because. After four bowls, the engine in the cabin began to make noise. The temperature after running 8-10 hours is 131 degrees. My setup is not perfect and that could be the problem. I would buy again and try to improve my setup if this one doesn't work.

Motor runs as intended but gets very hot. After three hours of operation, the motor is so hot that you will burn yourself if you touch it. After the first three-hour run, the sign on the side was so black from the heat that it was unreadable. I think after a few starts the engine dies and won't start but so far with a total time of around 12 hours it's still running. If I can find a 2-3 RPM, 120 volt, right hand rotation motor I will replace that.

07/04/2021 Worked for 30 minutes at a light load, an ambient temperature of 72 degrees and an engine temperature of up to 120 degrees. I wouldn't trust the windings to withstand continuous use as the winding insulation is not specified. The motor mounts are 2" on center and the shaft diameter is 5/16. Great motor for occasional use but how about a skewer? Definitely not for me. Any other experiences? Update 2021-08-27 1.25 hours have passed. The engine is on fire! Must order another one as I…