Cablecc USB 3.0 20pin Male to Female Extension Adapter - UP Angled for Motherboard Mainboard Review

DO NOT buy! Literally fell apart on my PC and almost clogged my USB plug forever! My USB connector kept scratching and chipping when trying to remove it! It's not worth it at all. Top upset about this garbage. This works fine as long as you don't try to remove it for literally any reason and then unlink it!

Works as intended. The adapter was necessary because my 3.0 port is on the bottom of my motherboard, causing awkward cable routing. This gave me the flexibility I needed to tighten the cables and make them look a lot better. The only wish is that it is completely black and not the blue underside.

Actually bought for my cousin who recently changed his case and is USB Type-C equipped. After placing an order I wasn't sure if this would work with the USB LINKUP type. The USB 3.0 port (see Z270MX Gaming 5) is located next to the -C port of the adapter, as is the case with its mainboard. Luckily, it's short enough that the internal USB-C connector and standard 20-pin connector sit on top of each other. I took off a star because I think the blue plastic shield isn't ABS material (I know some…

Update: I had to upgrade to a microATX case with a floppy disk drive and now the microATX board doesn't have room in the microATX case an adaptor. This product was almost impossible to remove. I nearly damaged the motherboard and luckily the USB port still works after I had to unplug the thing. As already mentioned, suitable for a microATX board in an ATX case. Not for an ATX board in a medium ATX case or a microATX board in a microATX case. Original: Ideal for a microATX motherboard in a…

I have not attempted to remove the adapter from the motherboard. Fits well and looks good so you don't have to try to remove them. My USB 3.0 has been carried around, can be difficult to remove. Be careful when using adapters and be careful when removing them, especially if they are already stable. The product works without problems on B450 Aorus Pro Wi-Fi. * Pay attention to what angle is needed, up maybe down on your motherboard. The climb angle for the Aorus was spot on.

The ASUS X470 Crosshair 7 Hero MB has a 20-pin USB 3 connector on the bottom of the MB. MB installed in NZXT H440. Without this adapter, the USB 3 cables are on the SSDs that sit on top of the power supply cover. With this 90 degree adapter, the USB 3 cable is now plugged in under the PSU shroud and the cable is NOW off the top of the SSD. It was basically a COSMETIC part of the setup. BUT it works and the case looks much better. The first photo shows the inside of the case without the 90…

Actually bought for my cousin who recently changed his case and is USB Type-C equipped. After ordering, I wasn't sure if this would work with LINKUP's USB Type-C adapter plug since, like its motherboard, the USB 3.0 ports are side-by-side (see Z270MX Gaming 5). Luckily, it's short enough for the internal USB-C and standard 20-pin connector to sit on top of each other. Miscellaneous. I took off a star because I think the blue plastic shield isn't ABS material (I know some type of plastic is…