Honda Rancher 350 TRX350 Carburetor - High-Performance Replacement for 2000-2006 Models Review

Works great! I had to disconnect the wire with the connector on the carb, but it worked fine. I have a Honda RANCHER Trx 350te and the choke was weird but still works.

This was extremely easy to install. No customization required. The only problem was that the carburetor heater plug did not fit. Just cut it off and replace it with the old connector. Suck the small holders on the vent pipes. And it's almost impossible to come back once you take them off. Next to. This is a great purchase. Distribution is easier and just as cheap as replicating.

My Rancher runs like new after a carburetor change. I've read that an old carburetor leaks gas because the float warps with age, so why not just replace the entire assembly. Very easy installation but the carburettor heater was faulty which blew the ignition fuse. Further research revealed that a carburetor heater wasn't necessary, so I unplugged it, replaced the fuse and was on my way.

let my rancher sit too long you know the story of old stale gas and water. I couldn't fix the old carburetor so I took a chance and ordered this carburetor. I reused my throttle cable and fittings, hooked up the throttle body, replaced the old fuel line and installed one of the filters that came with it. I installed the carburetor, hooked up two breather lines and turned the key... It fired right up and settled to a decent idle (even without using the choke). I increased the idle a bit and…