💎 Precision 0.8mm Jewelry Keychain for Optimal Casting Review

Bits will fall between the jaws. They don't tighten down the center of the cartridge, rendering it unusable. I really wanted it to work. I'm not a beginner carpenter. I have over 50 years of experience as a master carpenter and ship builder. I may have a defective one, but I don't want to risk replacing it with the same piece. I'll look elsewhere and so will you.

I like the grip for both weight and size. I'm used to thinner ones causing cramps in my hand. The spinner feels smooth enough. My biggest problem is my jaws. They seem to compress and tighten well, but have one hell of an awkward wobble. It's not too noticeable with a big 3mm drill, but at 0.8 it swings too much for what I need. The jaws just don't close evenly with anything inside. When closed without a bit, they appear to be fine. You can try looking for replacement jaws. would have been 5…

Failed to load media. I've never used a vice (although I've used a drill press for years) but this one works great. I use it to drill magnetization holes for weapons/equipment on Warhammer miniatures and drill barrels on their weapons. I use it with one hand while holding the model in the other hand and haven't had any problems so far. For your own health, apply some grease (I used WD-40) to the rear rotating assembly to keep it from squeaking with each revolution. As with any drill, be sure to