🏍️ Clutchlite 687012: Seamless Easy-Pull Clutch Upgrade for Harley Davidson/Buell XX-Soft Models Review

Takes 20 minutes to install but no instructions. Stand the bike upright, no need to drain the primary side. Make sure you have snap ring pliers handy. Once installed, the clutch is actually 30-40% easier to pull. The light part of the clutch itself feels premium and well made.

Clutchlite installed on my Harley Sportster 883 Low with immediate results, maybe 25-30% lighter clutch but as I've also switched to RSD levers that agrees bit difficult to quantify, except the clutch is now a lot lighter than before and a lot easier to use.

Product arrived quickly and was fitted to my 2011 iron and clutch adjusted within 20 minutes - time will tell the durability, the clutch definitely lighter, and that's because the clutch spring is 15% stiffer on my 883 after my 1200 upgrade -

After installing the clutch on my 2015 Sportster 883, it was very difficult to pull. Ordered a Clutchlite XX-soft as an alternative to a similar part that cost $172. Installed in 20 minutes and now it's really about 40% easier. Almost like my stock clutch. Definitely recommend this product. 👌🏼

Easy installation. If you are familiar with clutch adjustment, this will be easy for you! The derby cover will need to be removed so have a new gasket handy. My lid leaked like crazy when I reused the old gasket. Remove the ball train and use snap ring pliers to loosen the assembly. Install new part and reinstall. I would say 25% discount. 40% are generous.

Very easy to install and highly recommended upgrade part for regular clutch maintenance or Sportster garnet spring replacement. The feel of the lever is very straight and smooth, the machining of the part is well done and the ball bearings move smoothly on the ramps. *Be careful with the clutch adjustment as I turned the screw 1/4 turn clockwise past the end stop and that seems to be the sweet spot. much less than a standard clutch setting. Barnett Kevlar plates are also used, so this may have…

I installed Clutchlite 687012 Easy Pull Clutch and Twin Power Easy Pull Clutch Kit at the same time. It changed the world. It is now much easier to close and hold the clutch. It was very difficult to find neutral gear on my 2011 Road King and this setup helped a bit with that as well. It took about an hour, maybe an hour and a half. I was only able to remove the clutch cover with an Allen wrench without removing the exhaust. Also note that you will need to remove the primary cover and re-adjust