🏍️ CNCMOTOK Left Right 7/8" 22mm Clutch Brake Handle Levers Perch Compatible with Honda XR80 XR100 CRF70 CRF80 CRF100 Pit Dirt Motor Bike Motocross: Enhanced Control and Performance! Review

Bought and they are very easy to install BUT the hole the cable goes in is too shallow and needs to be drilled a little deeper , so the cable can twist around and go through the cable slot. Not a hard fix, but a solution nonetheless.

Fits my sons 1986 xr 80. Very easy to fit. Works great and would buy it again. The only problem I could see was that they were small for some people.

Bought these and they are very easy to install BUT the cable hole is too shallow and needs to be drilled a little deeper so the cable turned around and went through the cable slot.Not a hard fix but still a fix.

Both levers fit well on the XR80. The paint was so thick that it got in the way of the cable guide and the pivot bolt on the clutch lever. All devices were hand tight and had to be tightened. Most importantly, after 3 jerks while adjusting the position of the lever, the clutch lever broke and didn't even have time to ride. I'm giving two stars because the brake lever is what I needed and it still works.

One side fits perfectly, other needs sanding / Stem seat (was too shallow) Drilled 0.10" deeper / Cable duct (was too tight) had to make about 0.05 cuts on both sides to fit the brake cable in the channel and center it, 84 Honda ATC 200m with stock brake cables. It's a good deal when you can do your own accurate, great work. If too much material is removed, they break easily.