💻 Enhance Your Workspace with Cord Grommet White 1041WH Grommets - Perfect Organization Solution Review

Very cheap and flimsy but overall it hides a huge hole in the baseboard that I had to make to get the Monoprice cable through. I made a very precise hole but the grommet is still quite loose so it took a bit of construction glue to stick. The top part doesn't stay attached, just a light push and it pops right off, so you'll probably need some glue as well.

I recently drilled a hole in the wall to run a cable. I figured it was just a wire and I could probably make a nice clean 1/2" diameter hole without too much mess. After a few minutes I realized I had torn a terrible hole in the drywall, and I was adamant that I would find a solution to cover it up. I looked around for possible solutions and came across jacks. I then went to a few hardware stores and found that they only had these 1.5- 2" items have. This would require me to make a noticeably…

Almost perfect, but probably as close as you can get for under ten bucks. I would give 4.5 stars if Revane would allow it. I used two to hide the 35 foot LFE (subwoofer) cable - one where the cable enters one wall and the other where the cable exits the other wall. This will keep the holes looking clean and professional. The only thing that would make them a little better would be if the cylinder had some raised ribs. It's pretty slick and fairly slick so you'll need some caulk or glue to…