High-Quality White Plastic Flush Type Plugs for Industrial Hardware Applications Review

I needed to fill a 6mm x 10mm gap in the body of my car. I thought of some complicated ways to fill it, but these little kids made it really easy. You saved me a lot of work.

A bit pricey for small plastic parts but I needed them fast. Used them to plug the holes I drilled in my fridge/freezer lid after filling it with expanding foam. This should increase the time the food stays cold.

This is a true 1/4" unlike other brands which were too loose to stay in holes. They fit perfectly the adjustable 1/4 inch shelf holes in our white shaker kitchen cabinets.

Very easy to use. The holes left by removing the shower door were pretty ugly. Each hole is drilled to 1/4" and these plugs are easy to insert and snap into place. The lid is rubber so provides a good seal and greatly improves the look.

I had to move the shower curtain rod. These 1/4" plugs did the job of closing the previous holes. Please note: I had to fill the barrel plug with white joint compound because once you plug it in you can see if there is nothing behind the plug.

Absolutely amazing and worked great for what we needed. We removed the metal and glass shower doors and bars in our master bathroom, leaving 1/4 inch holes on either side of the doors. They just snap into place, are very snug and nothing sticks out behind them. 👍🏻👍🏻👍🏻

This is just what I needed for a fiberglass shower that required the curtain rod to be raised. Fits very snugly into 1/4" drilled holes. None of this will fall out. As mentioned, the center portion of the connector is somewhat see-through after installation, so a small bead of white caulk before installation will solve this problem. I didn't find it reprehensible so I didn't. Very satisfied. Highly recommended.

I found a key on an old bookshelf that works great. I worked the key on the left door but didn't open the right side door or the drawers. From the collection that was sent to me - it is important that you determine the size of the hole in the tip of the key you need by examining the lock carefully - I found 1 that works on both doors and drawers works great, another one that works but isn't as smooth. Definitely better to pay a locksmith!

This is really cool. They fit the 1/4" hole pretty snugly. I used mine on a shelf my wife bought with adjustable shelves. She didn't like the extra adjustment holes so I covered them with these plugs. tight but still slightly raised. I then used the end of a round screwdriver to align them. They almost disappear. Very happy with the results. You don't even see them moving away from the shelves. I highly recommend.