Today I twisted 2022-2500 pieces of self-tapping screws 5 * 50 into the corners, I don’t care for him, he drills under the studs on the Mauerlat 16 with a drill without problems

I am satisfied with the tool, of course, now it is worth looking towards a brushless tool. Didn't like that the batteries were dead. Maybe the tool is stored in the cold, I don’t even know how this is possible . And also, as usual with aliexpress, they didn’t put a warranty card. In authorized Makita service workshops without a guarantee, the tool will not be accepted for repair . I had to call the hotline 5 times and ask for a warranty card. After 1.5 months after the purchase, they still sent

If it were not for the overlapped roof from scratch, I would have rated it 2 stars. Shurik was bought for a promotion in April and lay for about 2 months almost idle, then tighten it up then tighten it up. They immediately forgot about it, and only on the second. And the fun began, bito fall🤣. 5-7 self-tapping screws, Shurik lower the bit at the bottom. The cartridge did not tighten. But then the campaign got stuck, the cartridge began to hold the bat dead. But now the cartridge began to hang…

Some pros: Comfortable enough. Resistant to slight temperature changes. Has some cons: I have a crookedly planted cartridge. When drilling, it does not interfere, but when assembling furniture it can be critical