CPU cooler Cooler Master Hyper 212 LED Turbo, white edition Review

If I had known such a moment about the cooler, I would not have bought it. I appreciate silence. But buying good coolers separately and laying out the cost of the entire tower is too much.

I bought it, installed it, forgot it, because it is quiet, dissipates heat well and of course beautiful. "Ryazhenka" 2600 under it has not risen above 60 at any games at maximum speed.

On am4, the installation is normal. There are two installation options. On the native backplate (if installed on the mother), but it will be upside down. And the one that comes with the kit. I installed the one that comes with the kit. So more like it.

On the mother of the Asus Rog Strix B350, I broke all my fingers while I stuck thiscomoler. The rocker clip is made so close that when fixing, the stone is ready to pop out from the back of the board. Diffusion from pressure is so great that thermal paste is not needed. On the AM4, thecomolers look up the case. . The problem with fasteners is known.

A good cooling system, silent (a system unit under the table), is more than enough for the Ryzen 7 3700X processor. I picked it up for the case in which all the coolers with a red stroke - it looks great! There are 3 types of fastening in the complex, you can just latch it - but it seemed to me less reliable, you can attach it to the site. I am satisfied with the purchase.

I put on a Ryzen 1600 overclocked to 3.8 and running at a voltage of 1.32-1.35 during the 11-hour prime95 test, the temperature at 100 percent of the revolutions jumped from 68 to 71 in the toys from 53 to 58 at 65 percent of the revolutions. You can throw in 1000 if you want and take something more powerful, but if the budget is running out and overclocking is no more than 3.8 on some budget motherboard, then it’s not a bad cooler.

Before that, I had an inexpensive dropsy, but her pump apparently flew, this often happens, as I read. After dropsy, I did not really want to switch back to a regular cooler, but I decided to try this one and did not regret it at all. I installed it on my native backplate, no problems. My CPU is already quite old, so a simpler cooler would be enough for it, so I can’t vouch for the cooling of modern processors, but I obviously have cooling with a large margin.

The temperature of the 1270v2 zone was about 55-65 degrees in idle and rose to 90 in the load. Now it’s 31-43 at idle, 60 at load. It suits me, I’m not an overclocker and in general I think it’s strange to drive modern super-productive stones, where to put such power is not clear. Also, due to the haste during installation, I directed the cooler towards the vidyuhi, however, the design allows you to put it correctly in about 5 minutes, when the hands reach))

Chesslovo, I took it because of the most aesthetically pleasing white cover. Still, for tempered glass, I place this business. Personally, I decided to minimize the total number of turntables in the assembly and put only 1 fan on the radiator, and use the second one to eject hot air from the rear wall. Aesthetically, it also looks good. Cools well 11400F, under synthetic load 67 degrees, rpm around 1100 rpm. In games, that is, with the video card being cooked, the temperatures did not rise…

Be extremely careful with the dimensions, do not be too lazy to remember the dimensions of your hull and calculate the available space, otherwise the circus with horses begins.

Disappointed cooler. It seems to be good cooling and low price. But a terrible mount on am4. If you don’t give up and unscrew the entire mount, you can break the motherboard, I was on the verge. Only for this I put one, to break the mother for 14 thousand because of the blunt fastening of the cooler, so-so pleasure. It turns out that stock coolers can be replaced with their own, if you peel off the plugs in place of the screws.

I took the cooler specifically for the Intel 7700K processor (I use it without overclocking). On Windows, it practically does not spin, i. E. the processor does not strain, but in the game (for example: black desert on high settings) 1-2 times per minute it gains frantic speed, somewhere for 1 second. After installing the motherboard with a cooler into the case, I noticed more problems: it is not possible to get close to some screws with a screwdriver, the hand, as you understand, does not…