🚗 Cruiser Accessories 30436: Enhance Your Ride with Red Reflector II License Plate Frame in Red/Chrome Review

I have had one of these Cruiser 30436 Reflector II Red/Chrome Tuf License Plate Frames on the back of my car since it was new (purchased February 2013) because got hit from behind four times and wanted to do my best to make the car more visible. The red plastic number plate holder I had on my previous car was muddy and dull but this one is in perfect condition more than 2 years after I replaced it with a dealer frame. It reflects the light well and fits perfectly. I am so pleased with the…

Too flimsy to work well as a license plate frame. It doesn't really have hooks to hook onto the license plate; it simply rests on the front of the panel and is attached to it with the same screws that attach the panel to my truck. And since my truck only has two license plate screws (at the top of the license plate), there was nothing to attach the frame to the bottom edge of the license plate. I bought some short flat head screws and nuts to attach the frame to the bottom edge of the board and

My car is black and after a rear impact I decided I needed a little more visibility. I'm not sure if a reflective number plate would have made a difference, but I couldn't get a white car at the time and wanted to do something to at least try to avoid a repeat. I didn't want my car to look gaudy and nothing permanent, and I didn't want an expensive solution like aftermarket headlights. I ordered this and I would say the reflectivity is higher than a regular bike reflector but not as good as a…

This is a very nice plastic license plate frame with Reflector. The casting quality is superb for both the chromed outer frame and the translucent red reflector area. It's only slightly larger than a standard number plate, making it suitable for most vehicles. The mounting tabs are small and flimsy, so care must be taken when assembling the frame. I added (4) 3/8" stainless steel washers under the mounting bolts to distribute bolt pressure over a larger area of the mounting tabs. Do not…