🔧 Compact DEWALT Brushless Drill Driver Review

The first one I got must have been a broken piece of equipment, I drilled 3 holes in my stainless steel tool box with a very small bit to install some handles and it froze. After trying to unlock it for a while with no solution, I figured Amazon would send a replacement unit. This is one of the main reasons to buy from Amazon, the replacement arrived within 2 days, I couldn't believe how quick it was, I boxed up the old one and sent it back straight away and they let me know when it was…

Tried 4 of these drills. They are light and very powerful. However, the ammo on all 4 was garbage. Overflow is too big. Also, they are riveted and cannot be replaced without significant risk of damaging the drill. If you set the drill to 2 levels and give it full throttle, the whole drill will vibrate in your hand. You can see the cartridge swinging. If only they used the DCD991 chuck they would have the perfect drill. Blade tip runout is approximately 1/8+ inch depending on tip length. This is

This is a high torque drill. Hold him tight while you drive the screws in, but be very careful, start slowly, or he'll twist the screwdriver (Phillips or flathead) in the head of the screw and snap it off. It takes practice and effort to slowly start this drill while screwing. And yes, it's the slower of the two speed settings. When drilling, the torque is high, just make sure you tighten the bit firmly in the chuck, otherwise the high torque may cause the bit to spin around the bit. Update…