DEWHEL Replacement Compartment 8E1880302B 8E1857124A24A Review

Works almost as expected. The hinges didn't fit as they were preformed and had to be adjusted. Some screws also turned out to be defective (head is intact, do not insert a screwdriver). I installed them on a good set of hinges to strengthen them and used epoxy to further strengthen the bracket and hinge.

the biggest problem is the wrong rounding! The screws do not countersink and are too wide. I spent two hours modifying them to make them work. Also, they don't come with new pins. Purchase at your own risk. There's a good chance you'll destroy your glove box unless you're very handy and have the ability to craft/modify parts.

These brackets are a good starting point. They are black, correct size and pre-drilled. But it took me a lot of effort to use them. This means you are ready to do the following: - reshape the entire brace to fit the cap and hinge - drill a countersink in each hole - replace the 2 large screws with small ones or throw them away - get some dremel out of the Take box Place the brackets. I would pay 4x more for it if the above work was not required. But my glove box is fixed so I'm happy.

Worked well with a little modification. My glove box hinge was completely broken. As previously mentioned, the holes in the bracket are not countersunk and the screws protrude too far, preventing the door from opening and closing properly. I used my dremel to narrow the screw holes; but even that didn't provide enough clearance as the screws were almost flush. A simpler solution is to simply notch the glove box itself. You'll never see that area, and it took about 30 seconds to change mounts…