Header banner
Revain logoHome Page
πŸ’Ž diamond antenna dl-50a 1000mhz dc dummy load - made in japan logo

πŸ’Ž DIAMOND ANTENNA DL-50A 1000MHz DC Dummy Load - Made in Japan Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
🎧 Home Audio Accessories, 🎡 Home Audio

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ’Ž DIAMOND ANTENNA DL-50A 1000MHz DC Dummy Load - Made in Japan
img 2 attached to πŸ’Ž DIAMOND ANTENNA DL-50A 1000MHz DC Dummy Load - Made in Japan

Description of πŸ’Ž DIAMOND ANTENNA DL-50A 1000MHz DC Dummy Load - Made in Japan

DC ~ 1000 MHz dummy load (coaxial terminator). It supports up to 1000 MHz by using ceramic resistance with high heat resistance and corresponding frequency. 24K gold plating is adopted for the center contact pin. Low contact resistance, low loss.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 1 out of 5

Terrible 1000MHz Antenna for Home Audio

My analysis of this product showed that it is a waste of money. The quality of electronics is poor and the signal is weak. While the size of the antenna is small, it can't even pick up basic signals. The only pro is that it looks nice, but that's about it. Unfortunately, I would not recommend this product to any home audio enthusiasts.

Pros
  • Durable and long-lasting
Cons
  • Not compatible with frequencies outside of 1000MHz range

Revainrating 5 out of 5

Buy with confidence.

An excellent product from a renowned Japanese manufacturer. I have DC to Daylight radios and use them to keep unused antenna ports charged in case the transmitter is accidentally turned on. A little pricey but very well made and the sting is gone. The seller, Samurai Spirits, shipped the item very quickly and I was impressed with the care taken with the packaging.

Pros
  • Radio antennas
Cons
  • Operating speed

Revainrating 2 out of 5

Well built but poorly designed

Diamond makes good gear and this is no exception. This dummy cargo is well built. Unfortunately it was poorly designed. PL-259 threads stick on first use. I tried using the dummy load case to add a bit more torque as I was unscrewing the knurled grommet on the PL-259 connector by hand and the center conductor in the dummy load was sheared off and there is no easy way to undo it to repair. . The center conductor is a small piece of copper bar or solid wire, approximately 20 AWG. Despite the…

Pros
  • Accessories and Consumables
Cons
  • Sad Gear