Dorman 03099 Exhaust Flange Hardware Review

Purchased these studs when replacing the manifold gasket on my 1954 Ford NAA tractor replaced. They are a little longer than the factory lugs but work great. I had all the necessary equipment and the handling was good. Everything fits perfectly and the brass nuts/washers should work better than the alternative steel nut products. This is a salvation as the original part is no longer available. Anyone wanting to replace bolts and/or work on the manifold should do some research to find out the…

This works as intended but I doubt the quality of the steel. Usually the bolts are hardened, but these are clearly not. Also others have mentioned this as to why they only give you three sets. The car uses four, two per distributor. A set of two or four people would be logical. Also one would be logical as you will most likely only have a damaged bobby pin. The threads on them are also different at each end. One end is ok and the other is ok. Factory bolts are intact on both ends. I believe…