🧼 DORMAN 42547 HELP! Wiper Arm - Ultimate Solution for Smooth Windshield Wiping Review

My youngest has just graduated from high school. Went to college and loaded the truck and 16ft trailer with my son's stuff. It started raining five minutes into the 7-hour drive. Ten minutes later the windshield wipers refused. The longest white knuckle turn I've ever experienced. I wish I had one of them with me. The installation took a maximum of 10 minutes. I bought a puller but I didn't need it. Fits perfectly. The washer nozzle also works perfectly.

. I can stand on my hands and avoid icing and freezing them overnight. Just make sure your car has a tapered (no ridges or grooves on the stud) or a smooth, tapered stud. In addition, if you do not have a small puller on hand, the old ones are difficult to remove. The puller works in seconds and is usually a recommended addition.

Ok this was an exact replica of the original part. The exchange took about 5 minutes. It turned out to be completely useless. After about 4 different blades I decided to replace the arm. My wiper went up off the window, missing the most important area in the middle. Thinking the problem was a weak spring, I replaced the lever. Did not help! Turns out all I needed was a good slat wiper. Before replacing the arm, try the expensive Trico Force wiper blade.

they faded. The sprayer on the factory bracket sprays slightly downwards and with a nicely distributed water fan over the windshield. The atomizer on this Dorman device simply pours water into the center of the wiper - this is an obvious difference that is unacceptable. Also, the part that the wiper blade attaches to is not at the same angle as the factory arm, causing the wiper blade to be at an awkward angle when parked. In addition, the metal is clearly not as durable as the factory…

This lever arrived and I installed it in 5 minutes and ordered an OTC wiper puller 4676 along with it to make removing the old one easier. I couldn't believe the difference, the old arm deteriorated for a long time and left streaks every time I had to use the wipers. I would replace the other side if I don't sell the truck next week. I had no problems with this hand. Just make sure you order the right side, it's for the driver's side. Since the splines were missing, this didn't affect the use…