Dorman Help 47408 Elbow Soft Review

I was looking for a reliable replacement part for my car's engine cooling and came across this product. As a result of my tests, I determined that it is an impressive Automotive Elbow Soft Replacement. The installation process was quick and easy, and I was impressed by the quality of the material used. The best part? It is reasonably priced, which is always a plus. The only downside is that it isn't very customizable, but that is a small concern when considering the product's overall value.

Any vacuum leak is always a problem. After 100,000 km, rubber seals wear out. That little elbow throbs with every rev up and down. But when a truck with a Magnum EFI engine has to make costly repairs because of a leak. Intake gasket, bad MAP sensor, AIC, TPS and O2 sensors. But not this little elbow? Stalls, misfires, won't start, rich conditions, rough idle, runs like garbage. If there are no codes, check the knee from the MAP sensor to the TB. If it spins freely or removes easily, it won't…

Bought this 90 degree elbow for the bouncer to use on a '95 Jeep YJ vacuum line to the fuel pressure regulator. The original rotted a bit after 25 years so I decided to replace it. This bouncer lasted exactly a year and broke at the 1/8" end and the 5/32 end started cracking in the adjuster. I understand it's a little close to the exhaust manifold, but the Jeep has less this year due to COVID 1,000+ miles on them They are not durable, bad material I had to keep the original it would have lasted