Doya Equalizer Harley LED Load Blinker Turn Signal Lights Resistor Flasher Relay Fix: Enhancing Flashing Efficiency for Improved Safety Review

Exactly what I wanted and not overpriced. I wrapped the ends in aluminum foil so they don't burn the other wires when they get hot.

I've tried several other brands and styles that cost $60-70 and they have not working. my 05 Electra Glide. It connected and worked immediately. It was worth buying all these LED bulbs.

Should have known after the first one fried and melted on the underside of my seat. They are garbage, I went through 3 sets. Each of them lasted maybe 1 ride, and then they fry the solder on the bottom that came from the heat. Spend between 60 and 90.00 and buy a good brand. Only put 1 star because you can't put zero stars. drive safe

This thing does exactly what you want it to do. Some reviews mention resistors getting hot, and they do, but that's what resistors are supposed to do. They absorb electricity and give it off as heat. If you've replaced your factory bulbs with LEDs and they are blinking too fast for your liking, this product will fix that. 2 minutes to install, just put the seat in place, disconnect the wiring harness, put the thing between the two connectors and put the seat back in place. That's all.

I drove my 2008 Road King for less than 20 minutes and noticed a burnt plastic smell and smoke. This device overheated so much that the insulation on the wires melted and shorted out. This could have been a much more serious situation if I hadn't noticed in time. These devices are dangerous. I returned it for a full refund and bought a Custom Dynamics stabilizer. The custom dynamic stays COOL and lets the LEDs work properly. This post is not an endorsement of Custom Dynamics, just information…