🔥 Introducing the Dr Infrared Heater DR-PS11524 Salamander: Ergonomic Yellow Heating Powerhouse Review

I bought this heater to heat my 3,000 square foot garage. I walked in it for 12 hours. A 6/3 wire was used and connected directly to a 60A switch. Since I needed a 55A switch, I spent about $250 on wiring materials. The problem is that this heater almost does not heat. It gives off warm air. I stand within 1 ft of him and it's like a heat gun blowing on me. Huge disappointment.

We bought the heater and used the 3 pin plug they recommended . The witch was 30 amps. The heater draws 60-something amps. Sent back now I check the website and they have a 50 amp plug. We tried a 50 amp welder but to no avail. Tried a 7500 generator, no luck. The interrupter keeps clicking. It appears to be a good heater, but not on a 30 amp cord.

I have Dr. Contacted Heather for the right attitude. The 4/3 sow used is connected directly to the 80 ampere switch. Spent around €400 on it. My problem is that this heater barely heats. Yes it blew warm air out, but definitely not as advertised for a 63 amp 240v BTU heater. I would not recommend this heater to anyone. He's well built and looks like a heat-radiating monster, but he's failed him many times. I will probably return this item.

Hello everyone. This heater is equivalent to a 50,000 BTU heater. This will be good for an isolated area. I use it to heat my daughter's house which is about 1800 sqm. 24 hours a day for 2 months. No fuel, no smell, less work. Note that electric heaters have large fans that cool the heating coil. So the perceived heat will not be hot, but wait half an hour and the room will become noticeably warmer. I love this heater and would recommend it to anyone. Remember this is not building heating where

I really wanted to like this device. I liked its size and portability. However, I could only run it at about 1/3 power or it would blow up my entire magazine. Not only the 50 amp 220 line it was plugged into, it also tripped the 60 amp circuit breaker in the main box in the house that powers my separate shop. I have a free standing 30x30 shop with 12 foot ceilings. He is "somewhat" isolated, but not very much. If you had enough switches to power this thing it would probably work great, but it…

I was hesitant to buy it because it didn't have many reviews when I got it but it worked great. In February, we heated a 3,200 square foot building in northern Idaho. Feet so we could plaster and caulk the drywall and it held a temperature of about 60 degrees while it was about halfway up. No temperature setting. Just a low to high scale so I don't know what temperature it should have been set to but it stayed there at around 60. We had insulated walls but no ceiling and it still stayed warm…