🍺 Premium 1-3/4-Inch Long Beer Nipple Shank: Chrome Plated, Stainless Steel Flange, 3/6-Inch Bore Review

The notch on the back is fixed and not removable so you can't change it to 90 degrees to work with most drawbar cooling towers as per the description at purchase.

Exactly what I wanted; a super short beer pole with a hose fitting welded on small enough to thread the hose through the beer threaded tri-clamp fitting on the side of my fermenters. This allows me to swap out the stainless steel dip tube I now use for a float and hose to tap beer from any desired depth.

I added a faucet handle to the front of the fridge. I used a hole saw to drill a hole in the fridge door for a beer leg. I used a slightly larger hole saw to cut the inside out to make room for the included nut to tighten directly onto the fridge door sheet metal. I filled the interior with insulating foam.

These are just what I needed for my beer faucet system, but when they arrived none of the three I ordered had the nut that secures the faucet on the stick. This ring shown in the picture has two visible holes (there should be two more on the back). I am returning them and asking for 3 more and hope they will be completed as advertised. Update: Requested a replacement and all three replacements were missing the faucet mounting nut. Unfortunately I have to go somewhere else for that. I don't know

I bought two of these and they didn't come as advertised. They are listed and shown with a swivel nut to fit the stem to the beer faucet. Nobody came with a nut. I tried to exchange them and specifically stated in my exchange request that I needed them with a swivel nut. Two new items have arrived, but still without the necessary union nuts. I see I'm not the first reviewer to come across this. Stay away as there seems to be a lot of stock of defective products packaged without the required…