2.5-inch SSD/Hard Drive to 3.5-inch Bay Metal 💽 Tray Mount Adapter Caddy for PC – Reliable SSD Holder Review

Works as advertised and intended. quality metal. No unnecessary bends or kinks. Suitable for standard drives. Cheap price.

Turns out I didn't need it. That's a good thing, too, because it didn't fit properly in my hard drive bays. The holes on the side are too small. I think this might just be my case (Phantom 240) as it comes with built in adapters so I'm leaving it at 5 stars. In any case, the screws are included.

The case is very light and has no mounting holes on the bottom for attachment to some hard drive holders that have a long through-screw with soft Use silicone mounting pads . as is common with Antec drive bays and other computer cases. The mounting holes on the sides work well if the bay allows for side mounting screws.

There's nothing wrong with the intrinsic quality of this drive tray, but the SSD sits too far when you screw it in. The edge connectors are on the back edge of this cutout. When attached to sliders and mounted in a drive bay, the rectangular connectors on the cables could not be connected because the wires were pointing down and there was not enough room in the drive connectors for them. This may be unique to my application, I can't tell. Consider how to install this b4, you will buy it.

I was looking to upgrade an old Stata hard drive in my HP 8200 Elite SFF and wanted to use an SSD. Due to the proprietary hard drive mounting system in the HP sff case, I had to drill a bit of mounting holes on the adapter tray, otherwise it works like a charm. The new SSD is fast and secure.