Header banner
Revain logoHome Page
πŸ”Œ ds18 fd1024 38afs 60a holder distribution: premium performance in power distribution logo

πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸ‘·β€β™€οΈ Circuit Protection Products, πŸ’‘ Industrial Electrical

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution
img 2 attached to πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution
img 3 attached to πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution
img 4 attached to πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution

Description of πŸ”Œ DS18 FD1024 38AFS 60A Holder Distribution: Premium Performance in Power Distribution

AFS Fuse Holder with 60A Mini ANL Fuse. 1x0GA + 2x4GA In, 3x8GA Out. Durable Finish and Conductivity. Easy Installation for Multiuse Combinations. Solid Construction Designed and Engineered in USA.

Reviews

Global ratings 3
  • 5
    0
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

None of the high quality 1/0 OFC materials will fit

Wire will not fit. The holes are not fully drilled as you can see in the photos. Next to the unprotected distribution box DS18. The hole is square unlike the unfused block, making it impossible to install the wire without cutting 1/3 of the strands.

Pros
  • Fuse blocks and fuse holders
Cons
  • Ugly packaging

Revainrating 4 out of 5

Simple but gets the job done.

I have bought a few DS18 products and they have all been the same so far. None of them stood out as amazing, but none of them wasn't a bad product either. I have a 3 position fuse holder and it does the job. The branding could be a bit smaller and not cover the entire cover.

Pros
  • Fuses
Cons
  • Cable is shorter than others

Revainrating 4 out of 5

Good but has a design flaw

This is a great little fuse holder but with one major flaw which isn't really a big deal but might bother some. The fit looks good, the problem is the fuses are flat. You have to stand at an angle and the reason is that if a fuse blows you have to remove all the fuses to replace the one that blew or at least remove the end fuse to replace the middle fuse. I have used several of these fuse holders and if you have several they usually set the fuse at an angle to allow you to easily remove each…

Pros
  • Tools and Housewares
Cons
  • Some bugs