🔌 DT MOTO Nilight 2PCS 16AWG LED Light Bar Wiring Harness Kit: Off Road Lights Power Relay with On/Off Switch, 12V, Blade Fuse, LED Work Light - 2 Years Warranty Review

This worked very well on a Jeep Cherokee 30" LED roof strip. I had to lengthen the two wires that went to the light, but everything else worked fine. The wires are a bit flimsy. and the way how the wires fit to the top of the switch is a bit odd but it has been used almost every day for the last few months and it seems to work fine Wiring the lights is MUCH easier and quicker. There were no instructions but basically everything is already set up for you. I will continue to buy them.

I read the reviews, a lot of bad reviews were mentioned. But it was one of the best companies to deal with. I buy a lot of items from cheap to expensive depending on need. There was a bit of confusion as to what I bought where for my needs. The kit didn't work, there was a problem. But that's not because of the parts. I contacted DT MOTO. We found the problem, a simple fix was made and in two days they had the part I needed on hand. Can't say enough good things about these guys. Make sure you…

Only buy this if you're willing to do some electrical work. I'm only ordering this for the relay and fuse holder. which is good because the rest is not very good. The schematic in the description is an accurate representation of the wiring harness, but for my use on a 2008 Jeep Wrangler X, the wires from the switch connector and relay were too short to return to the battery. The connector on the switch side was uncrimped and 2 of 3 wires were pulled out of the contacts. This gives you an…