🚗 Enhance Visibility with Eagle Eye LED Chip Car Fog White Light DRL Bulb 9W 18MM 5730 Reverse Backup Parking Signal 10pcs 6000K Review

Unreliable product. The LEDs' domed plastic lens fell off and they only lasted about a month with minimal use before flickering and slowly dying.

5 months have passed and the lens has fallen off in two. 7 burned out. And one flickers. There were high hopes that after installation they looked great (if after that the appearance of Raptoe ((parking light in the grille)) is now just sad.

I bought a box of Amao. And added these lights. They are very bright. And low power consumption. I power them with a small 12v 7 amp battery. And I was lit up all night The only wire is very thin. So take your time and you will have great success.

The housing of the LED separates from the lens as soon as I try to secure it with the nut provided. Very cheap and brittle aluminum or what it is. I will not buy again. On each of them, the threaded part is pulled out. There is NO way to leave them where you want them in their holes unless you want to glue them or something. Useless.

Four of my lightbulbs went out within a month of purchase because I had drilled holes I bought a second pack to replace four that failed even two weeks later I had to have two replace more, I don't recommend these lights, although nice and bright they don't last. I installed them in a safe grilling location so you get what you pay for. I won't buy them again

I bought these for the interior lighting in my CJ5 but was a little disappointed with the light block dangling inside the aluminum case. Only a wire held in place by a blob of black silicone keeps them in place. I dug most of them out of silicone and fixed them with epoxy. Of course, I just glued the wire, but that at least allowed me to fit the flashlight into the housing where it wouldn't rattle.

I ordered a custom made daytime running light for my car. During the manufacture of one of the LEDs, 1 microcircuit burned out even before installation. The LED chips aren't fixed inside the case, just a rubber membrane gasket holding the cable where you can wiggle the cable and move the LEDs around inside - maybe sit around? After a 6 hour install in less than a week, 1 LED burned out on my setup. like the pictures, and the other one is full of water. Very disappointing

These lights are great for illuminating areas near light sources, they are not bright enough to project further than 5 feet. Installing the lights was pretty easy, but the wiring was a little tricky. These wires are very, very thin. There are only a few strands of wire no thicker than a strand of hair to work with. I was able to connect them to the main wire and solder them so they stay connected. It would be impractical for me to make a connection without soldering. My setup was for my mower…

This is a pair of white LED crystals behind the projector lens. The housings are threaded for a standard drum hole, making them easy to assemble. They draw about 30mA at 12.0VDC and behave as if they had resistive current control and not chip control, with the current rising to 13.8V. They are very bright. Although used as non-automotive panel lights I'm very happy that they work great as emergency lights with 12v batteries. The lead wires are very small so soldering the leads directly to the…