Edge Products 38405 Pillar POD Review

Perfect color match with my 17th Tradesman 2500, CTS2 fit is fantastic, could fit a little better on the rack but that is the minimum clearance at the top edge. Integrates the CTS2 into the dashboard and eliminates blind spots on the windshield.

Looks and fits like an OEM part. I've seen some people say the windshield bulges a little. I will use a piece of velcro to attach it. But overall it's expensive for a piece of plastic. But it looks really good. Tip: Do not tighten the screw to fix it to the rack post, work by hand first, you can remove it easily, hope it helps.

This seemed very cheap for the price we paid. The fit or texture did not match exactly. I attached it with a couple of screws because it wasn't flush. It scratched my window tint in the bottom corner because, as mentioned, it doesn't quite match. But in general it looks nicer than the suction cup mount. To each his own.

Doesn't fit well leaving big gaps on the edges, I've had several of these edge mounts in different truck models, this one is by far the disappointment for you It doesn't matter what your interior looks like , and you need something to hold your programmer, this will do the trick, but if you want a client to look good I wouldn't recommend just sticking with the sucker.

I bought this for my 17 Ram 5500. The color goes very well with the storage rack. However, the texture is completely different. It fits pretty well, except that it made me a little tighter on the right side. If it were shaped a little smaller it might have more memory in the plastic to hold that side down because it's only held in place by one screw. I bought this to mount my mm3 which it is not designed for. However, it can be made to work. I used a razor blade to trim it a bit and made the…

Overall good looks and fit but not perfect. The color and texture are slightly different, but I think most people won't notice or notice. I've been doing classic restoration for about 10 years and have been accused of OCD. I had to trim my piece at the bottom of the windshield corner a bit to install it, but the top inside corner near the windshield still doesn't match the A-pillar. I may put some thin double sided tape to hold it in place but I'll see how much it bothers me while driving. The…