🍞 EDGELEC Breadboard Assorted Multicolored (Optional) Review

These are needed if you want to connect your 3D printer to the ELEGOO UNO R3 ATmega328P ATMEGA16U2 Board. printer, you need both, and both worked without problems the first time. It's that simple. It's like having the right tools in a box in case something goes wrong. If you are flashing your printer's firmware, you must have these two items. Otherwise, wait for them to come to your house so you can set up the printer properly. Otherwise there is not much to say about cables. They worked. They…

Pros: • Easy to use • Kit consists of all 3 types of jumpers • Fast shipping, well packaged • 4 mockup projects done with it Cons: • CANNOT replicate more than one project at a time - another dazzling one of each type would be nice, although it would cost a little extra change • A few parts broke / or the metal leg fell out, not often enough to be a big problem • Some of them will protrude from the holes in the breadboard socket if pulled too hard. Just pay attention to their length before…

Pros: • Easy to use • All 3 types of jumpers in the package • Fast shipping, good packaging • 4 layouts made with it Cons: • It CANNOT do more than one project design at the same time - it would be one more rainbow ribbon of each type would be nice although it would cost a little extra modification • A few pieces broke/or the metal leg fell out, not often enough pose a big problem • Some of them stick out when they are pulled too hard, out of the breadboard socket holes. Just pay attention to…

These worked great for my original purpose of flashing the Tasmota on the Sonoff Zigbee Bridge. However, the ends are too large to easily fit into the connection point holes on the Sonoff PCB. But the ends are actually just bent (not quite tight/round), so using pliers I was able to compress/deform them just enough to fit into the holes in the board for a tight connection, and the firmware ran smoothly! Additionally, the female to male and post to male transitions using a breadboard made it…

These are some of the best mini PV/Dupont jumpers I've seen. I ordered a set of 120 pieces. in an assortment of 20 cm and I am not disappointed. Very flexible and very easy to divide each strip of 40 conductors into groups of one or more conductors. to the end of the body. This does not include the length of the pins which add an additional 6.3mm to 12.6mm depending on the M/F or M/M type. The fork ends (which I tried to show in the attached photos) are crimp terminals and appear curled into a…