🔒 EFIELD Stainless Steel PEX Cinch Clamp Rings - 100 Pack for 3/4 inch PEX Tubing Pipes Review

Was shorted when purchased. Only received 49 of 50 rings. Otherwise the product works as intended. Note: I haven't done a pressure test yet.

Works great. I needed a few more to complete the project and they were the fastest to get without going to the store and paying twice as much. All the ones I've used have worked great.

Husband required them for simple outdoor plumbing jobs and reports they worked as required. Unfortunately we couldn't buy them locally - we live in a small coastal town. The local hardware store has a very limited selection of items. They arrived quickly (we have Prime) and in good condition along with other items I ordered.

I've tried a whole pack of clamps from other brands and over 80 percent of them wouldn't tighten properly and I had water leaks everywhere. I had the arduous task of removing the original faulty clamps and installing these. None of them failed and they fared better in every way.

Took the water heater to the garage. Many PEX fittings due to the incorporation of a thermostatic mixing valve, vacuum breaker and pneumatic tank. Not a single leak. We needed to change the route of a line, which required removing some clamps. Which work. Of course, we really should have discovered the problem before crimping. Very happy with Efield PEX products.

I am sticking with the 3/4 inch ring due to the lowest unit cost of purchasing the item. as I could tell. For DIY projects using PEX pipes, if you haven't experienced it, be sure to buy extra rings. You'll go through them like candy and easily underestimate the amount. You will need 2 rings for each installed fitting. , except for haircuts where you need 3. That adds up quickly and is very frustrating when you don't have enough.