Kemimoto X3 Electric Device Tablet Holder: Replace OEM #715002874 for Can Am Maverick X3 (2017-2022) – GPS Mount included Review

Although fully working it doesn't fit properly on the dashboard at all. The screws tighten it a bit, but there are still big gaps, especially on the leading edge. I'd probably buy a Can Am if I had to do it again, although it does the job well enough. The gaps allow some water to get in, so it's not fully splashproof.

Latch keeps front door closed when not installed. But when you install and tighten it, it deforms the plastic a bit and just opens the wings. unusable. You can only use it if you don't put it away. Installation should be very easy, but there are no instructions.

Purchased for our Can Am Maverick X3. Looks good. Directions suck. The protective case was developed by the Chinese. I would really reconsider your mount. Now it's just a glove box. Comes with an iPad holder mounted on a roll bar. If not off-road - go. But it looks a bit thin

Works great. The fit isn't perfect as the bottom is open, but easily folds into the desired shape when you tighten the set screws. If I had to reinstall I would use a door seal with a channel to place it on the unit prior to installation. I rode the iPad about 200 miles off-road, no problem. As a bonus, I stored my "Dual GPS" puck and still maintained a great signal.

Although fully functional, it doesn't fit very well on the dashboard. The screws tighten it a bit, but there are still big gaps, especially on the leading edge. I'd probably buy a Can Am if I had to do it again, although it does the job well enough. The gaps allow some water to get in, so it's not fully splashproof.