🔥 RIVERWELD PT-31 Plasma Tip Nozzle Electrode Extended Cutting Consumable - 40pcs for CUT-50 & CUT-40D Review

Works great on my Cut 50 Yes they don't last long but for the price I won't complain! The cutting quality with fresh consumables is in no way inferior to the quality of significantly more expensive machines.

I use these on an inkjet plasma torch, they fit great except either the consumables are too long or the filaments break, there is about a 1/8 inch gap between the ceramic and the torch . body

They have been listed by Revain as 'frequently purchased together', compatible with Morphon cut50F pilot arc with 'AG60' torch. They are NOT compatible. I didn't need them 2.5 months after buying the plasma cutter so I discovered the problem after the return window. Go to Revain!1 - Revain collects commonly purchased items together or crafts them by combining incompatible items.2- Don't buy consumables until you have a plasma cutter so you can be sure of what you need

Exactly what you expect from consumables. Some have complained or commented that there is a 1/8 inch gap between the white cone and the rest of the burner when screwed in. This is not a problem. This allows the copper components to be easily screwed all the way in to ensure a tight copper-to-copper connection. The problem arises when you cannot fully screw in and tighten the white cone. If this were to happen, the copper parts would not be firmly bonded together and would prematurely arc inside

Fits my LOTOS LT5000D (not LTP5000D) with a "redesigned" probe/torch. Torch blue with yellow or orange inserts/ball valve Appears to be of good quality. The only "problem" I had was having to move the small red o-ring to the burner tip, just above a lip, to get a tight seal. It took me a second to figure it out, but I did. They are probably 20-30% larger than the parts that came with the lotos, again they still work, you just have to slide the o-ring up. I suppose with the larger size they…