🚗 AutoForever Engine Motor Trans Mount Set 4PCS for 04-09 Mazda 3 2.3L without Turbo - Compatible with A4403 A4404 A4405 A4418 Review

Ideal. Little did I know these cars are prone to assembly problems so severe that companies are forced to sell these kits. My mount was so bad the engine/transmission was almost ready to fly out.

Great set at a great price. About 2.5 hours for full installation with YouTube videos with step-by-step instructions. The shop required over $1,000 in parts and labor to complete. All parts fit perfectly on my daughter's Mazda 3 2005th machine.

Passenger mount doesn't fit, the mount doesn't fit like it did from the factory, even tried turning the insert around. Didn't make it better. I had to reuse the stock mount. Nevertheless, the hydraulic support lasted 2 days. The gearbox mount fits perfectly but is noticeably cheaply made compared to the factory. Rubber is not as dense as the original, summed up on day one.

As a previous reviewer noted, the motor mount is set back on the passenger side. nothing is obviously being done about it. created what could take anywhere from 20 minutes to over an hour or two to take it apart and insert it back to front. still not sitting. Now I have to order a brand new part to replace this unique bracket.

The Revain filter said they fit my Mazdaspeed3 07 but that's not true. The description of this kit says it will fit, but if you look closely only the rear bracket will fit. I don't think they should be marketed as fitting the Mazdaspeed3 (although that may be partially true). On the plus side they seem to be of very good quality and would definitely order them again if they were indeed compatible.

I have a Mazda 3 2009 2.3L hatchback and like others I had to flip the center bushing in the bracket as it was backwards. I had all the equipment for it and everything looked perfect afterwards. The new mount was a little shorter than my old one, but the holes matched so I could mount it normally. However, the bracket broke on the first disc. I'm not sure why, it wasn't a stalemate or anything. Do not purchase this kit, order a separate passenger pillion mount and ensure you purchase the…

The passenger mount did not have a slightly extended leg on one side causing the engine to move about 0.5-1cm away from the engine. in front of the car. It would be possible to bolt it on if the motor is pushed/forced back into place, but not knowing what 'bad' pressure it can put on the gearbox and such I just ended up with another mount on the Bought passenger side. correct design from another supplier. The other two mounts are easy to install and appear to be of decent quality after about…

The damping part was mounted the wrong way around in the bracket. I had to take it off and put it back on. I had to bend the wing lugs and then hammer them back into place once I had them in the correct orientation. Not a big deal as if I had ordered from a local parts store it would have come without the bracket. I would have to remove the broken hydraulic damper from the old bracket and install the new one the same way. 2 stars because I ordered it on purpose so I didn't have to worry about…