🚗 Enhance Your Vehicle's Performance with Flow Fx 2.50" (Off/Cen) Exhaust Muffler Review

I took it on my expedition and people didn't believe I just replaced the muffler. a truly unique sound. good price. quieter at idle. loud when stepped on

Previously installed Flow Master 10s. It was too much hum for me, especially at highway cruising speeds. Swapped them out, it was a lot more fun. The drone is gone but still has a great sound and hasn't lost too much volume.

Best value for money. Just a ritual sound for my truck. Not loud when you're going at any speed, but when you step on it it perks up and gives you that raw horsepower sound. I have a replaceable cam in my 350 exhaust manifold with a drain into a catless 2 1/4" Y-pipe that was converted to a 2.5" Flo Fx muffler and then a 2 3/4" tailpipe. How it sounds.

This is the best way to go if you are looking for a slightly deeper sound from your muffler but not annoying, hoarse, growling or rousing. neighbors in the morning. I used it to replace the stock resonator and connected the rest directly to the muffler tip. I was surprised by the overall sound coming out of my muffler setup. It sounded better than the expensive $800-$1200 catback units on the market. This will be the third setup I've done for my car and I'm finally very happy with it. And it…

Very good quality muffler. The input and output jack is 2.5, sorry if my terminology is wrong, but you can plug your typical 2.5 straight into either end. It was wrapped in bubble wrap and had only one very small dent, which might even have been intentional. It sounds low compared to other modified cars, but it is MUCH better than the stock. It has the deep growl of a Subaru, but doesn't have a neck twist, which is what I was looking for. To my surprise, it sounds clearer at idle and 2-3k rpm…