🖤 Enhanced Formula & Expanded Size: Everlasting Black Bumper & Trim Kit Review

Great product but requires some concentration. The secret to no streaks is this: 1. Clean the surface with this solution or a strong degreasing soap and allow to dry in the sun or heat.2. Put in a place away from direct sunlight or heat.3. Apply first coat as evenly as possible and wait 15 minutes (may look like shit but will be blank) - Start at one end and make smooth, even strokes (e.g. sponge will absorb more than sometimes applied. 4. Apply 2nd coat and wait 15 minutes again (looks better…

This thing is amazing. The photo I posted doesn't do it justice. small effort. The kit comes with a special concentrated cleaner which is 64 oz, I mistook 16 oz. It was more than needed for a bumper. I rubbed the bumper with a new Scotch-Brite kitchen sponge, rinsed and dried. The kit comes with a perfectly sized sponge applicator and I apply a small amount of polish in a small plastic cup at a time. Path. I took my time in the shade and the results were stunning. Any issues this material may…

Not sure I want to try this plastic finish color. But my Escape's running boards and rear bumper pad went from black to mottled light gray. Following the directions, use a cleaning concentrate and use an air hose to blow off excess water and dry crevices and crevices. USE PAINT TAPE to protect paint and glass surfaces next to faded surfaces. It only lasted a few minutes. Not sure how much to use, I applied 3 lighter coats which really brought the jet black finish back to how it was when it was…

I bought this to put the black back on my 2005 Jeep Wrangler Bushwacker. They have a nice texture but have almost faded to a gray color after a long winter of salt, sand, wind and snow and I was looking for something more permanent than the usual protectant. Eraser and again rubbed with a degreaser. At this point they were almost white. The applicator you receive leaves streaks on a large surface and it is extremely important to apply this material in the shade. Direct sunlight makes it…

1 year ago I used a lot of peanut butter on my wings, 1 year ago I used "rewash" and this product still worked. I first used a large amount of 91% IPA with paper towels and some of the old paint came out, then I used half the cleaning solution and did two full and deep microfiber cleanings a day apart. (The bucket on the left is the bucket with cleaning solution, on the right WAS clear wash water that turned black) Then I dried the wings, waited 10 minutes and started practicing. Not sure if…

This product works very well if you use it correctly and use the best applicator. I have used it on several automotive black plastic surfaces with fantastic results. Here are the steps based on my experience and some wise feedback on Revain. 1- Prepare the surface: the first thing to do is clean the plastic surface to be painted. You can't clean the surface too much. Use these three steps: a- Use your regular surface cleaner and a stiff cleaning brush. Some recommend Dawn dishwashing liquid. I…