🔌 Frigidaire 316557118 Authentic Control Board for Ranges in Sleek Black Finish Review

The relay on my previous control board literally blew up. I did some research and found this article and found it to be a decent amount to try and fix instead of spending hundreds on a new oven. The board closed just like the old one and I noticed that the design was actually better than the one I removed. The connections between the boards were not made with bent metal pins but with real wire harness, which is a nice touch. Everything fitted well and worked immediately after switching it on…

Update: I purchased this item on June 1st and it failed the first week of September. So, 3 months and done, we get the same F30 code as before. I checked the temperature sensor, it works fine, the board is out of order. I give 2 stars because it was easy to install and worked within a short time. It was an exact replacement for a spare part so repairs were easy! Just make sure to mark (photograph) the cable attachment points on the back of your old one before you unplug them. Heat the edges of…

Bought this module to replace the current one that was causing uncontrolled temperatures in the oven. This new one started doing the same thing within the first two weeks. Our oven is a Kenmore and has had an intermittent temperature problem for the last 12 years which has gotten out of control. We have isolated the problem to the electronic control module and have replaced it many times over the years. This is our fifth module, but we've never seen it fail as quickly as this one. The warranty…

This Frigidaire part has extended the life of my Kenmore 790.96122405 electric range made by Frigidaire. Plug and size were exactly the same as the old block. Basically, disconnect about 5 individual color-coded wires from the connectors, then unplug the pin header. 4 hex screws hold the device in place. If you want to reuse the cover of the original device, carefully remove it and put it back on the new device. The tape around the perimeter of the face is very tacky and in my haste I…

This is a dead simple replacement, especially if you turn off the power and follow these four steps: 1. Remove the screws from the old part of the control board only, but do not disconnect the wires and then attach the new one part with screws to the oven2. This new part does not come with a color matching front panel of your original oven, but the original control panel front panel is only attached with tamperable adhesive. Remove the plastic cover from the old block and properly attach it to…

This circuit board is a genuine replacement for the circuit board in my oven part number 316418208. that it has ever been used or connected to another oven. I had to remove the white display cover from the old circuit board, which stuck pretty well and left some white around the edges when I took it off. So when I hooked it up to the new control board, a few black dots were visible. however, everything matches the cover of the old board. connecting was super easy too. Anyone brave enough to try