🚘 Enhance Your Car's Aesthetics and Illumination with the FXC 2x Car LED License Plate Tag Light 12V or Convenience Courtesy Door Step Lamp Review

Excellent LED Lights. Dispatched and delivered quickly and on time. I replaced the factory warning lights on my 2011 GMC Serria pickup with these LED black lights. They're pretty bright, but not as bright as I was hoping. Make sure you have a good solid base for the lights or they will be very dim or not work at all. Hope they meet my requirements.

Fairly bright for three LED lights. However, they were a pain to get up and running. I've never seen a 12VDC light that is polarity sensitive. Also, the white LED should be ground/neutral and the black LED should be 12VDC/hot. Usually the black US wire is the ground circuit. Therefore, they only work in wired mode. But they eventually worked.

I ordered this light for a trailer license plate and never got it to work. The description said a 12V DC LED would work in my opinion. Tried all different settings with pickup 1500 and 3500 never turned on. Bought just in time so they arrived before a long trailer ride, now I had to glue the battery LED up until I got to the auto parts store. The only way to turn them on was to plug them into a household outlet, which is a 120V outlet. Never again.

I used these bulbs for accent lighting in my truck. Brightness at full 14V is reasonably good, but not blindingly bright like other LEDs. The housings are sealed with silicone and there is foam on the back of the lamp to keep moisture out. Note that the wires exit straight back, there is no cutout for routing wires under or above the lamp when it is flush with the surface.

White LED but barely bright. Enough for a trailer license plate. into the dark night. The second light is designed for a small cargo space for a trailer. The "dimensions" of the product refer to the box of two (2) lanterns and not to the units themselves (small ones). Overall Width 2.5" (Mounting Holes 2" center to center), Top-Bottom 1.1", Front-Back Depth 1.0". Enough cables to plug in (8 inches), cables exit through a centered hole on the back, thin foam backing doesn't feel weatherproof…

I bought these for a small electronics project that needed a well packaged light mounted at a 90 degree angle to a vertical surface. Each license plate light draws 13.6mA at 12V or approximately 0.16W per lamp assembly. The mounting plate is 2.55" x 1.17" x 0.16" thick. ). The actual light body is 1.2" high (including foam padding and base) x 1.585" long x 0.97" " wide. The recessed mounting holes are approximately 0.2 inch in diameter. Cable length 8.5". Cable diameter (insulation) 0.074"…