🚗 Enhance Your Vehicle's Style and Performance with the Go Rhino! GRT234410 Exhaust Tip Review

Great quality for the price on a Silverado, you need to cut your old exhaust pipe down to about 5 inches or it looks silly, it has a little deeper sound difference.

Fits my 2018 Silverado and looks just as good as a very expensive one from the dealer. Ease of installation. No cutting or hammering. Nut slipped and tightened. Good to go!

4.5 stars. Perfect fit for 2018 Silverado 1500 5.3 made for this truck. Not sure why Amazon says it doesn't fit, glad I listened to the comments. There is no drainage hole at the bottom, I had to drill that, so minus half a star for that.

Perfect fit for my 2014 Silverado 5.3L. The finish looks great. The yoke is a good ribbon yoke, not a cheap U-shaped pull yoke. It's 10 inches. I was thinking of a 14 inch but I'm glad I got this one. 14 would be too long with a factory exhaust. I cut off about 3 inches of the exhaust pipe with a hacksaw.

This is a great exhaust tip for the latest GM trucks! I installed mine on a 2014 GMC Sierra with a 5.3 engine. The 5.3 has a 2.75" exhaust. This tip has the correct internal diameter and length. The weight and quality of the chrome is very good and the clip is excellent. I highly recommend it!

Looks great on my '96 Silverado and fits perfectly after I cut off some stock tailpipes. It also made the truck a little louder and softened the sound a little around 1000rpm so I fell in love with this thing and it offered more than I expected! I'll post a photo when it's not that dirty in here and I actually have a clean truck.

I ordered this chrome exhaust tip for my 2019 GMC Denali and installed it in minutes. It fits my truck perfectly and I'm very happy with how it looks. However, I have a small problem with the product. The tip of the device is nicely twisted, creating a place for moisture to collect. In my case, prior to installation, I drilled a tiny hole at the lowest point, out of sight, to drain the water.

Looks great! When I took it out of the box I was afraid it would be too wide and look silly. After a trial installation on a regular exhaust, everything looks fine. I cut 3 inches off the bottom of the tube so it's flush in the top. This allowed the tip to stick out from under the case just enough to show the 🦏 logo. Hope it holds up over time. I just installed a Magnaflow silencer so the haters in the background can see the difference.