Xenon Depot LED Bulb, H11 Xtreme LED Pro: Upgrade Your Forward Lighting with Pure White, Ultra Bright, Plug and Play Design - (1x XD.LED040) Review

The installation on my 2020 4Runner Limited went very well. I chose this one hoping to keep the original dust cover. It turns out that the PSU, cables, and heatsink fit under the cover, leaving (barely) any room. Much brighter, whiter and better than halogen bulbs. No early signs of an electronic compatibility issue. I hope they work as well as the install. So far I'm really happy.

Easy install, great lighting upgrade for my 2015 4Runner. And best of all: NO DRILLING in the dust cover or similar. All wiring and harnesses fit into the low beam housing. A rubber grommet is included if you feel like drilling through the dust cover (requires a 1" hole) but this is NOT required. Watch the video of the guy and the orange 4Runner for more instructions. I only did low beam, no fog lights or high beam, so I can't comment on that.

Bought after several weeks of careful study of the 4Runner forums. The 4Runner has an odd low beam housing, so not all LED kits will fit. Even with the right kits, most won't work and most require fans for the LEDs. I wanted the low beams to be brighter and whiter to match my fog lights. This will impress you. Just look at the picture! An adjustment is not required. No drilling. Fans are not required for cooling! I hooked them up in about 15 minutes. Increasing the brightness really makes a big

Pros: Good modern white light. It was set to the 3-9 o'clock position right out of the box, so no adjustments were needed. No fan buzz like some other brands as fins.cons are used. Lots of extra cables and extra harnesses. If you have a dust cap, it fits very well when using the fins in the 5th gen 4runner chassis. Check out my photo versus Morimoto 2stroke. I'll probably drill a hole in the dust cap and use the included grommet to route the wiring harness on the outside of the case to make…

Bought these headlights for my wife's 2020 4Runner trd SUV after buying another brand but another brand I bought the fan was too big and didn't fit tightly in the headlight housing causing the Light glowed unevenly when driving. Took them out and bought these XD LEDs and couldn't be happier. Spacious, and this time the light shone evenly. They were more expensive but I'm sure they fit perfectly. I recommend them to 4runner owners. Another brand that didn't fit was ALLA. I have these on my 2017…

These Xtremes feel good when first installed, they fit well in a 2017 Kia Sorento but blade adjustment is a little tricky. There is plenty of room in the case so no drilling is required, but it can be useful to keep the glass box away from heat sources. As for the light output, see the two photos I've added. The second photo is the first light output with no adjustments, the second is the pure cutoff angle. Slightly lower than it should be to avoid glare. So let's talk about the light output…