🔩 Enhanced Bearing Capacity of 3-Section Extension Hardware Review

I used this product in a project to make a tool rack with drawers. I needed paragliders that could handle the weight and the performance was enough. I only opened one end of the box and took out one pair at a time. Each pair is wrapped in plastic, making the process easier. There were no screws in the box and no instructions as to whether they were included, so I went out and bought them. It wasn't until I had removed and installed 4 pairs that I came across a package of screws. I tipped the…

The 20" drawer slides are not what I expected. Firstly the screws provided are of very cheap quality I had to pre-drill each hole or break the screw heads before you can fully tighten them The top Phillips screws are not centered which makes screwing them in awkward as they wobble and some were very small and unusable I threw the extra screws in the bin 1 of 6 sets was defective on arrival I knew that was a bad sign when I opened the bag and a couple of loose bearings fell out The metal holding

I bought the 16" rails when they were $38.99 so they've gone up a bit since then. I took a chance because there weren't many reviews on them, but they were a lot cheaper than similar full size drawers at Revain. There were no complaints about their quality. As I gained experience as a carpenter I built a second nightstand to match and used a Kreg drawer puller to install them. I was GOT of the differences. The reason the first bedside table didn't move entirely smoothly is because my drawers…