Review on 🔩 Enhanced Bearing Capacity of 3-Section Extension Hardware by Nick Narvasa

I bought the 16" rails when they were $38.99 so they've gone up a bit since then. I took a chance because there weren't many reviews on them, but they were a lot cheaper than similar full size drawers at Revain. There were no complaints about their quality. As I gained experience as a carpenter I built a second nightstand to match and used a Kreg drawer puller to install them. I was GOT of the differences. The reason the first bedside table didn't move entirely smoothly is because my drawers were probably pretty much out of square (meaning the side pieces were probably not horizontally parallel. You can use Kreg's mount to even out any warped/non-square pieces and the runners move incredibly smoothly on the 2nd bedside table.These drawer slides are high quality.y One thing not mentioned in the instructions and a must do when installing is to use the holes that line up all the way There are 3 on each slide. The reason you need to do this is that if your drawer is too narrow, the slides may bend towards the drawer to accommodate the drawer that is too narrow.