🌤️ HiLetgo Precision BMP280 3.3 Atmospheric Pressure Sensor Review

Wrongly ordered but found out from another IC sent by same company. I now have incredibly accurate life readings for the height and temperature of my plant cabinet haha. I leave it because it's beautiful. If you get nan with the Arduino library, make sure the last pin is connected to vcc or ground, whichever i2c address you want to use!

Device works great. I'm impressed with the accuracy and stability. It remains to calibrate a little. Just go ahead and get about 4-5 pressure points from different airports in your area. Average those measurements, then turn around and get the sensor reading, and then subtract it from the average, take that difference and remove it. It's about 40 or so. Once that calibration is in your code. It remains without any real changes. I ran this thing 3 days straight and measured once a minute with…

I tried many times to get it working, at first four of the five worked fine but after several hours of data collection one showed a lot of junk information then the tooltip sent none Data more, two more did so over the next few hours. One kept puffing normally, but gets finicky when I do a lot with it. do, but the breakout is intended to eliminate the need for an additional wire to the CS pin) and will gradually heat up as the data is sampled until it stops working (but never smokes), you'll…